What are the two batching methods of the concrete batching machine? Our technicians have concluded that the concrete batching machine is divided into: belt type and cylinder type according to the batching control method. 1. Belt batching type: its structure is mostly a raw material storage hopper at the upper part, a measuring hopper at the lower part, and a discharge conveying belt at the bottom. Its principle: when the batching starts, the belt conveyor starts to bring out the raw materials in the storage hopper to the set value, and the belt stops. Then, under the control of the control instrument, configure the next several materials in turn. When all the materials are configured, the instrument control starts the discharge belt to The material is sent to the next link (such as mixer lifting bucket or conveyor belt conveyor, etc.) belt batching type is mostly used in small and medium-sized construction sites. Because of its small material base, in order to further improve the batching accuracy and reduce the error value without affecting the distribution efficiency , can use low-speed batching, fast unloading method. In order to reduce the procurement cost, users who use this type of batching machine hope to use the weighing bucket of the batching machine to measure the bulk cement at the same time, and push the cement in the cement silo into the weighing bucket of the batching machine through the cement screw conveyor. Generally, this usage is not recommended. Because of the good fluidity of the cement, a small amount of cement will overflow between the metering bucket and the conveyor belt, resulting in on-site dust pollution or cement loss. Soft and thin ribs can control cement spillage. 2.Cylinder batching and batching machine: its structure is mostly the upper part is the raw material storage hopper, in order to increase the storage capacity, the heightened plate is set up, and the lower part is the measuring hopper: an integral measuring hopper can be equipped under each batching door, so that each material can be added in sequence For the same weighing hopper (cumulative measurement), a single weighing hopper (each weighing each material) can also be set under each batching door, and the material that has been measured will be sent to the next link by the bottom belt conveyor. The cylinder batching type uses the gravity gravity of the material to flow downstairs, so the batching speed is fast, and it is suitable for medium and large batching plants. At present, concrete batching plants (floors) above ZJ50 are mostly used.